Brieftextverarbeitung- Druckerkonfiguration-OKI 3990- Drucker Setup umgebauter Drucker
Info:
Druckerkonfiguration - BTS
Einzelblatt
Kopfzeilen 0
Textzeilen 70
Linker Rand wahlweise
Schönschrift wahlweise
Endlospapier N
Zeilen/Blatt 70
Formular Drucker - IDFM
| Formulardrucker: | 4 (IBM Proprinter) |
| Einzuglänge in mm: | +42 |
| Linker Rand in mm: | 00 |
| Schönschrift | ein: 1B 49 02 |
| aus: 1B 49 00 | |
| Fettdruck | ein: 1B 45 |
| aus: 1B 46 |
| Unterstreichen | ein: 1B 2D 31 |
| aus: 1B 2D 30 | |
| abw. Druckeinst. | ein: 0E |
| aus: 20 |
| Sonderfunktion 1 | ein: 1B 57 31 (Breitschrift) |
| aus: 1B 57 30 | |
| Sonderfunktion 2 | ein: 1B 0F (Schmalschrift) |
| aus: 12 |
| Reset |
1B 33 24 1B 43 48 12 |
| Drucker Setup | umgebauter Drucker | |
|---|---|---|
| Printer Control | Emulation Mode | IBM PPR |
| Font | Print Mode | Utility |
| Font | Pitch | 10 CPI |
| Font | Proportional Spacing | No |
| Font | Style | Normal |
| Font | Size | Single |
| Symbol Sets | Character Set | Set II |
| Symbol Sets | Language Set | ASCII |
| Symbol Sets | Zero Character | Slashed |
| Symbol Sets | Code Page | USA |
| Symbol Sets | Slashed Letter 0 | No |
| Symbol Sets | Euro Sign | Enable |
| Rear Feed | Line Spacing | 6 LPI |
| Rear Feed | Form Tear-Off | Off |
| Rear Feed | Skip Over Perforation | No |
| Rear Feed | Page Length | 12 " |
| Bottom Feed | Line Spacing | 6 LPI |
| Bottom Feed | Form Tear-Off | Off |
| Bottom Feed | Skip Over Perforation | No |
| Bottom Feed | Page Length | 12 " |
| Top Feed | Line Spacing | 6 LPI |
| Top Feed | Bottom Margin | Valid |
| Top Feed | Page Length | 11 2/3 " |
| Top Feed | Wait Time | 1 sec |
| Top Feed | Page Length Control |
by Actual Page Length |
| Set-Up | Graphics | Bi-directional |
| Set-Up | Receive Buffer Size | 8k |
| Set-Up | Paper Out Override | Yes (oder No) |
| Set-Up | Print-Registration | 0 |
| Set-Up | Operator Panel Function | Full Operation |
| Set-Up | Reset Inhibit | No |
| Set-Up | Print Suppress Effective | Yes |
| Set-Up | Auto LF | No |
| Set-Up | Auto CR | No (Standard) / Yes bei Problemen |
| Set-Up | SI Select Pitch (10 CPI) | 17.1 CPI |
| Set-Up | SI Select Pitch (12 CPI) | 12 CPI |
| Set-Up | Time Out Print | Valid |
| Set-Up | Auto Select | Yes |
| Set-Up | Graphics Speed | Low |
| Set-Up | Centering Position | DEFAULT |
| Set-Up | Select Language Set | Combined |
| Parallel I/F | I-Prime | Buffer Print |
| Parallel I/F | Pin 18 | +5v |
| Parallel I/F | Auto Feed XT | Invalid |
| Parallel I/F | Bi-Direction | Disable |
| Serial I/F | Parity | None |
| Serial I/F | Serial Data 7/8 Bits | 8 Bits |
| Serial I/F | Protocl | Ready/Busy |
| Serial I/F | Diagnostic Test | No |
| Serial I/F | Busy Line | DTR |
| Serial I/F | Baud Rate | 9600 BPS |
| Serial I/F | DSR Signal | Valid |
| Serial I/F | DTR Signal | Ready on Power up |
| Serial I/F | Busy Time | 200ms |